MINI Controller MINI full color led controller I.Wiring The controller has 4 wires, which are power on behalf of the red line (VCC), black (two) represents the grounding wire (GND), blue represents product line (DIN). The micro controller and the lamp string connection: four leads respectively connected to the micro controller, usually red, black, blue and red, black, light blue are correspondingly connected. (if not corresponding, wire color please control the instructions.) Then the positive red line and the external DC power supply is connected with the cathode, black line and the external DC power supply is connected with the external DC power supply, which is to the microcontroller power supply and power supply to the lamp string. II.Operating instructions Observe whether the power supply and working voltage (before power on the controller has 5V and 12V two), to ensure that no short connecting line between the phenomenon. The micro controller with 3 buttons. Boot default state: water, whole jump, meteor, single point, colorful gradient, forward after water six state cycle changes. Press the MODE key: From the first to the sixth times, each time with a style, and maintain a single style of circulation. The first: the overall jump second times: water Third: the meteor fourth: single point Fifth: colorful gradient sixth: forward after water 1 MINI Controller Press the SPEED key: Each time a deceleration. A total of eight step speed regulation. Not to support the accelerated adjustment. When you press the ninth times to return to the original default rate. Press the AUTO button: display style and speed back to the initial state. The micro controller with power down to keep the function, in the use of the process if unexpected power outages, displays the last data will be in next startup (style and speed). III.Pictures 2